(Combine 45 pieces for a 15M diameter circle)
$18.25
Designed to accommodate vehicle traffic, the SNAP-IT™ Driveway Curve gives you a smooth, reinforced curve for driveways and wider paths.
Strong, clean, and built to match your layout, this section locks into your system just like a straight edge, no need for custom forming.
SNAP-IT™ Driveway Curve is best for:
The SNAP-IT™ Driveway Curve is built to handle high-traffic areas and vehicle loads. It’s the go-to choice for curved driveway entries, parking bays, and garden edges that need to stand up to regular use.
SNAP-IT™ Driveway Curve installation tips:
Always use steel reinforcing rods to support the structure; two 6mm rods in parallel are recommended for heavy-duty use. Secure with Lock Pins to hold both the form and the rebar in place before pouring concrete. Use a wet concrete mix to ensure full flow into the mould and tap sides to eliminate air pockets. For consistent results, set a string line or mark out your curve using the SNAP-IT™ Builder first.
Calculate how many SNAP-IT™ Driveway Curves you will need for your project with our custom calculator.
Flat Rate Shipping
North Island $40
South Island $68
Simple DIY System
No contractor
Available Factory Direct
Flat Rate Shipping
North Island $40
South Island $68
Simple DIY System
No contractor
Available Factory Direct
Proudly made in NZ
Our products are good to go, and work for heaps of jobs around the section.
SNAP-IT™ kits are made to fit all kinds of projects, garden beds, driveways, paths, and more. Browse real-world examples from around the world.
Our products are good to go, and work for heaps of jobs around the section.
Use the SNAP-IT™ Builder to sketch your project and calculate exactly how many SNAP-IT™ Driveway Curves you’ll need for a clean, concrete-ready finish.
Coming soon!
You’ll need a spade, snips (for trimming components), steel rebar (included in most kits), a hammer or mallet, and a SNAP-IT Finishing Trowel (included in most kits or sold separately). A string line or chalk is helpful for layout.
Use the SNAP-IT Builder (coming soon!) to plan your layout and calculate how many straights, curves, and elbows you’ll need. Or choose a pre-made kit that suits your project size and shape.
Yes, all units can be trimmed with snips for smaller spaces. Always leave a 10–20mm overlap between pieces for strength and a snug seal.
SNAP-IT edging units are made from durable, injection-moulded plastic designed for strength, stability, and ease of use. The forms are non-biodegradable and intended to be left in place as part of the finished concrete edge.
While not reusable, SNAP-IT pieces can be recycled through standard household collection systems in New Zealand, provided they are fully cleaned of any concrete residue first. Check with your local council for specific recycling requirements.
